Original Blue Label Oil Wood Finish
Penofin penetrating oil wood finish is formulated to enhance
and protect the natural beauty of any variety of wood. Use
Penofin oil wood finish on any exterior wood surface where
a transparent finish with ultraviolet protection is needed.
- Brazilian Rosewood Oil penetrates deeply to protect against
moisture.
- Hardens and protects individual wood fibers.
- Transoxide pigments virtually eliminate the fading due
to sunlight.
- Penofin won't fade, turn chalky, or wash off.
- No surface film to trap moisture or cause chipping and
peeling.
- Wide range of transparent and semitransparent colors.
Blue Label Oil Wood Finish
is available in ten colors.
Blue Label Oil Wood Finish Application Tips
SHAKE PRODUCT WELL BEFORE USING. DO NOT add thinning or blending
agents.
Apply Penofin to a clean, dry surface. Surface must be
free of dirt and sawdust build-up. DO NOT APPLY IN DIRECT,
HOT SUNLIGHT (when wood is hot to the touch).
Brush on, use a stain pad, or spray on (garden or pump
airless sprayers) one coat of Penofin.
For maximum penetration wait 30 minutes, then use a nap-free
shop cloth and wipe the entire surface removing any excess
product.
Surface will be dry to the touch in three hours and ready
for use in 12 hours
When using the one-coat formula, the application is now
complete.
If using the two-coat formula, wait a minimum of three hours
and apply a light second coat and again wipe any excess from
the entire application area.
Caution & Warnings
Combustible - keep this product away from heat, open flame,
and sparks.
Beware of spontaneous combustion. Make certain all rags
or other materials used with Penofin are soaked in water,
stored in an air-tight container, or otherwise disposed of
safely.
Gallon Coverage
Smooth surfaces: 200-300 square feet. Rough surfaces: 125-175
square feet (a gallon) for both coats of Oil Wood Finish.
Product Performance
Expect 2-4 years on vertical surfaces, 9-18 months on horizontal
surfaces depending on use and weather exposure.
|
Log-On